FixVault
Home › Chevrolet › 2009 › Chevy Express G1500, Van Cargo, 4.3 X › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - 4.3L - Introduction › Repair Instructions › Crankshaft Position Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: Removing/Installing Crankshaft Position (CKP) Sensor Wiring Harness Electrical Connector
    GM1950052Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the engine wiring harness electrical connector (4) from the crankshaft position (CKP) sensor (3).
    3. Fig 2: View Of CKP Sensor & Bolt
    GM1877000Courtesy of GENERAL MOTORS CORP.
  3. Remove the CKP sensor bolt and sensor.
About FixVault