FixVault
Home › Chevrolet › 2009 › Cobalt SS, 4D Sedan › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 2.0L - Introduction › Repair Instructions › Manifold Absolute Pressure Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: MAP Sensor Connector
    GM1825525Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector (2) from the manifold absolute pressure (MAP) sensor.
    2. Fig 2: MAP Sensor & Bolts
    GM1828338Courtesy of GENERAL MOTORS CORP.
  2. Remove the MAP sensor bolts.
  3. Remove the MAP sensor and O-ring seal from the intake manifold.
About FixVault