FixVault
Home › Chevrolet › 2009 › Equinox LS, AWD › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (Engine Controls And Fuel - 3.6L - Introduction) › Repair Instructions › Accelerator Pedal Position Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Accelerator Pedal Position Assembly
    GM898158Courtesy of GENERAL MOTORS CORP.
  1. Install the upper attachment bolt into the APP assembly.
  2. Install the APP assembly into the vehicle.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the remaining attachment bolts into the APP assembly.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    4. Fig 2: View Of APP Sensor Harness Connector
    GM927716Courtesy of GENERAL MOTORS CORP.
  4. Connect the APP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.
  5. Install the CPA to the APP sensor harness connector.
  6. Install the driver knee bolster. Refer to Knee Bolster Replacement .
  7. Install the instrument panel left lower closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
About FixVault