FixVault
Home › Chevrolet › 2009 › HHR LS, Automatic › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 2.2L Or 2.4L - Introduction › Repair Instructions › Camshaft Position Sensor Replacement - Intake › Installation Procedure

Installation Procedure

    Fig 1: Identifying CMP Sensor
    GM1578483Courtesy of GENERAL MOTORS CORP.
    NOTE: Inspect the CMP sensor for damage. Replace as necessary.
  1. Lubricate the CMP sensor O-ring seal with clean engine oil.
  2. Install the CMP sensor.
    CAUTION: Refer to Fastener Caution .
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: Identifying CMP Sensor Electrical Connector
    GM1639712Courtesy of GENERAL MOTORS CORP.
  4. Connect the intake CMP sensor electrical connector (2).
  5. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
About FixVault