FixVault
Home › Chevrolet › 2009 › HHR LS, Standard › Repair and Diagnosis › Body & Frame › Ignition Switch/Steering Lock › Wiring Systems And Power Management - Introduction › Repair Instructions › Ignition Lock Cylinder Control Solenoid Replacement › Installation Procedure

Installation Procedure

    NOTE: Clean the solenoid and plunger with a lint free cloth prior to installation. Oil or debris may cause ignition lock cylinder solenoid malfunction.
  1. Install a new spring over the ignition lock cylinder solenoid plunger.
  2. Carefully install the new ignition lock cylinder solenoid over the plunger.
    3. Fig 1: View Of Ignition Lock Cylinder Solenoid
    GM854930Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Seat the ignition lock cylinder solenoid on the lock cylinder case housing and install the screws.

    Tighten:  Tighten the screws to 2 N.m (17 lb in).

    4. Fig 2: View Of Ignition Switch Harness Connector
    GM854934Courtesy of GENERAL MOTORS CORP.
  4. Connect the lock cylinder solenoid harness connector.
  5. Install the steering column trim covers. Refer to Steering Column Trim Cover Replacement .
  6. Check the operation of the ignition lock cylinder solenoid.
About FixVault