FixVault
Home › Chevrolet › 2009 › HHR LS, Standard › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (Engine Controls And Fuel - 2.0L - Introduction) › Repair Instructions › Fuel Tank Pressure Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Tank Pressure Sensor
    GM1636702Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel tank pressure sensor to the module. Ensure that the sensor grommet is fully seated in the module.
    2. Fig 2: Identifying Fuel Pressure Sensor & Fuel Pump Module Electrical Connectors
    GM1636698Courtesy of GENERAL MOTORS CORP.
  2. Connect the fuel pressure sensor electrical connector (4).
  3. Install the fuel tank. Refer to Fuel Tank Replacement .
About FixVault