FixVault
Home › Chevrolet › 2009 › HHR SS, Automatic › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 2.0L - Introduction › Repair Instructions › Crankshaft Position Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: Identifying Engine Oil Pressure & Crankshaft Position Sensor Electrical Connectors
    GM1716603Courtesy of GENERAL MOTORS CORP.
  1. Remove the starter. Refer to Starter Motor Replacement .
  2. Disconnect the engine wiring harness electrical connector (1) from the crankshaft position (CKP) sensor.
    3. Fig 2: Identifying CKP Sensor
    GM1578475Courtesy of GENERAL MOTORS CORP.
  3. Remove the CKP sensor bolt.
  4. Remove the CKP sensor.
About FixVault