FixVault
Home › Chevrolet › 2009 › HHR SS, Standard › Repair and Diagnosis › Body & Frame › Ignition Switch/Steering Lock › Wiring Systems And Power Management - Introduction › Repair Instructions › Ignition and Start Switch Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Ignition Switch
    GM854768Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the ignition switch and screws on to the steering column.

    Tighten:  Tighten the screws to 2 N.m (17 lb in).

  2. Connect the ignition switch harness connector.
  3. Install the steering column trim covers. Refer to Steering Column Trim Cover Replacement .
About FixVault