FixVault
Home › Chevrolet › 2009 › HHR SS, Standard › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 2.0L - Introduction › Repair Instructions › Fuel Tank Pressure Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: Identifying Fuel Pressure Sensor & Fuel Pump Module Electrical Connectors
    GM1636698Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement .
  2. Disconnect the fuel pressure sensor electrical connector (4).
    3. Fig 2: View Of Fuel Tank Pressure Sensor
    GM1636702Courtesy of GENERAL MOTORS CORP.
  3. Position 2 flat-bladed screwdrivers, one on each side of the sensor, near the vacuum port.
  4. Using the screwdrivers as leverage, carefully pry up in order to release the sensor from the module.
About FixVault