Backup Lamp Replacement

WARNING: This page is about a different car, the 2008 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Backup Lamp Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedure Open the liftgate. Remove either the LH or RH rear quarter trim panel access hole cover. Disconnect the electrical connector at the backup lamp bulb socket.
1	Nuts, Backup Lamp Assembly (Qty: 3) Tighten: 6 N.m (53 lb in)
2	Bracket, Backup Lamp Assembly Tip: Pull the bracket toward the front of the vehicle off the backup lamp studs.
3	Lamp Assembly, Backup Tip: Remove the lamp assembly from the exterior of the rear body panel.