FixVault
Home › Chevrolet › 2009 › HHR SS, Standard › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Steering Linkage Outer Tie Rod Replacement › Installation Procedure

Installation Procedure

  1. Position the NEW rack and pinion inner tie rod nut at the match mark on the inner tie rod.
    2. Fig 1: Identifying Tie Rod Inner Jam Nut
    GM854976Courtesy of GENERAL MOTORS CORP.
    NOTE: Install the rack and pinion outer tie rod end the same number of rotations as counted during the removal.
  2. Thread the rack and pinion outer tie rod end onto the rack and pinion inner tie rod.
    3. Fig 2: View Of Tie Rod End & Steering Knuckle
    GM854972Courtesy of GENERAL MOTORS CORP.
  3. Install the rack and pinion outer tie rod end to the steering knuckle.
    4. CAUTION: Refer to Fastener Caution .
  4. Install a new rack and pinion outer tie rod end nut.

    Tighten:  Tighten the nut to 25 N.m (18 lb ft).

  5. Tighten the rack and pinion inner tie rod nut an additional 90 degrees.
  6. Install the front tire/wheel. Refer to Tire and Wheel Removal and Installation .
  7. Adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .
About FixVault