FixVault
Home › Chevrolet › 2009 › Impala SS › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 5.3L - Introduction › Repair Instructions › Manifold Absolute Pressure Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: View Of Electrical Connectors
    GM1551867Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  2. Disconnect the manifold absolute pressure (MAP) sensor electrical connector (2).
    3. Fig 2: View Of MAP Sensor
    GM1411911Courtesy of GENERAL MOTORS CORP.
  3. Remove the MAP sensor (714) from the intake manifold.
  4. Remove the MAP sensor grommet (715), if required.
About FixVault