Installation Procedure

WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Do Not is install the motor/actuator at this time.

Transfer the sunshade. Refer to Sunroof Sunshade Replacement (CF5) .

Fig 1: View Of Sunroof Module

Courtesy of GENERAL MOTORS COMPANY

With an assistant, position the sunroof frame assembly to the roof ring.

CAUTION:

Refer to Fastener Caution

Install the sunroof frame bolts to the roof ring and tighten to 10 N.m (89 lb in).

Fig 2: View Of Sunroof Motor Base Bolts

Courtesy of GENERAL MOTORS COMPANY

Using the access hole in the sunroof frame cross bar, install the push-pin fastener which secures the rear sunroof water gutter to the roof. If equipped.

Fig 3: View Of Sunroof Rear Drain Hose

Courtesy of GENERAL MOTORS COMPANY

Connect the rear sunroof drain hoses to the drain spout.

Fig 4: View Of Sunroof Front Drain Hose

Courtesy of GENERAL MOTORS COMPANY

Connect the front sunroof drain hoses to the drain spout.
Install the sunroof window. Adjust as necessary. Refer to Sunroof Window Replacement
Install the motor/actuator to the frame before initializing the motor. Refer to Sunroof Motor/Actuator Replacement , and Sunroof Motor/Actuator Initialization/Teach Process (Existing Motor) , Sunroof Motor/Actuator Initialization/Teach Process (New Motor) .
Verify that the electrical connector is connected to the sunroof motor/actuator and window is operating properly before installing the headlinder.

Fig 5: Disconnecting Electrical Connector From Motor/Actuator

Courtesy of GENERAL MOTORS COMPANY

Install the headliner. Refer to Headlining Trim Panel Replacement (without DE1) , Headlining Trim Panel Replacement (with DE1)
Inspect the sunroof for proper operation.