FixVault
Home › Chevrolet › 2009 › Impala SS › Repair and Diagnosis › External Pages › Different car › Section 199 (Stationary Window System) › Repair Instructions › Window Replacement - Liftgate › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Liftgate Window Glass
    GM1480112Courtesy of GENERAL MOTORS CORP.
  1. Install the stationary window into the opening. Refer to Urethane Adhesive Installation of Stationary Windows .
  2. Use masking tape (1, 2) to hold the liftgate window into position until the urethane adhesive cures.
    3. Fig 2: Disconnect/Connect Rear Window Defogger Electrical Connector
    GM1480114Courtesy of GENERAL MOTORS CORP.
  3. Reconnect the rear window defogger electrical connector (2).
  4. Install the wiper motor. Refer to Wiper Motor Replacement - Rear in Wipers/Washer Systems.
  5. Install the liftgate trim panel. Refer to Trim Panel Replacement - Liftgate in Interior Trim.
  6. Close the liftgate.
  7. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
About FixVault