FixVault
Home › Chevrolet › 2009 › Impala SS › Repair and Diagnosis › External Pages › Different variant/trim › Section 4 (Engine Controls And Fuel - 3.9L - Introduction) › Repair Instructions › Fuel Level Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Electrical Terminals
    GM2029362Courtesy of GENERAL MOTORS CORP.
  1. Push in the electrical terminals (1) and ensure the terminals are secure.
    2. Fig 2: Identifying Locking Tabs
    GM2029355Courtesy of GENERAL MOTORS CORP.
  2. Carefully insert the level sensor until the locking tabs (1) snap into the locking position.
  3. Install the fuel tank module. Refer to Fuel Tank Module Replacement .
About FixVault