FixVault
Home › Chevrolet › 2009 › Traverse LS, AWD › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - 3.6L - Introduction › Repair Instructions › Ignition Coil Replacement - Bank 1 › Removal Procedure

Removal Procedure

    Fig 1: View Of Ignition Coil Electrical Connector
    GM1860397Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector(s) (1) from the ignition coil(s) (4).
  2. Remove the fuel injection sight shield. Refer to FUEL INJECTOR SIGHT SHIELD REPLACEMENT
    3. Fig 2: View Of Ignition Coils
    GM860797Courtesy of GENERAL MOTORS CORP.
  3. Remove the ignition coil bolt(s).
  4. Remove the ignition coil(s).
About FixVault