FixVault
Home › Chevrolet › 2009 › Traverse LS, AWD › Repair and Diagnosis › External Pages › Different car › Section 24 (Engine Control System & Fuel System - 3.6L - Repair Instructions) › Repair Instructions › Throttle Body Assembly Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Throttle Body & Bolts
    GM1858235Courtesy of GENERAL MOTORS CORP.
  1. Position a NEW throttle body gasket (1) and throttle body (2) to the upper intake manifold.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the throttle body bolts (3).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    3. Fig 2: Identifying Electronic Throttle Control
    GM1858234Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector (2) to the electronic throttle control (1).
  4. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  5. Perform the throttle learn procedure. Refer to Throttle/Idle Learn .
About FixVault