Installation Procedure

Fig 1: Positioning Stabilizer Shaft

Courtesy of GENERAL MOTORS CORP.

Position the stabilizer shaft on the frame.
Install the left and right stabilizer shaft insulators and brackets. Refer to Stabilizer Shaft Insulator Replacement .
Install the stabilizer shaft links to the stabilizer shaft. Refer to Stabilizer Shaft Link Replacement .
Using the jack stands, raise the front cradle into position.

Fig 2: Identifying Front Frame Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Tighten the front frame (2) bolts.
Tighten: Tighten the frame to body bolts to 100 N.m (74 lb ft) plus 90 degrees.
Tighten the front frame reinforcement mounting bolts (1). Left side shown, right side similar.
Tighten: Tighten the reinforcement bolts to 50 N.m (37 lb ft).

Fig 3: Locating Rear Frame Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

Tighten the rear frame mounting bolts (1). Left side shown, right side similar.
Tighten: Tighten the frame to body bolts to 100 N.m (74 lb ft) plus 90 degrees.

Fig 4: Identifying Frame Reinforcement Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

Tighten the rear reinforcement bolts. Left side shown, right side similar.
Tighten: Tighten the reinforcement bolts to 50 N.m (37 lb ft).
Remove the adjustable jack stands.
Install the bolt from the intermediate shaft bracket to the front cradle. Refer to Front Wheel Drive Intermediate Shaft Replacement .
Install the outer tie rod ends to the knuckle. Refer to Steering Linkage Outer Tie Rod Replacement .
Install the rear propeller shaft, if equipped. Refer to Propeller Shaft Replacement .
Install the front tires and wheels. Refer to Tire and Wheel Removal and Installation .
Remove the support and lower the vehicle.