FixVault
Home › Chevrolet › 2009 › Traverse LS, FWD › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - 3.6L - Introduction › Repair Instructions › Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake › Removal Procedure

Removal Procedure

    Fig 1: Identifying Intake & Exhaust Camshaft Position (CMP) Sensors
    GM1860428Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine mount strut and bracket. Refer to ENGINE MOUNT STRUT REPLACEMENT - RIGHT SIDE and ENGINE MOUNT STRUT BRACKET REPLACEMENT - RIGHT SIDE .
  2. Disconnect the engine wiring harness electrical connector (1) from the bank 1 intake camshaft position (CMP) sensor (2).
    3. Fig 2: View Of CMP Sensor Bolt & Sensor
    GM1860459Courtesy of GENERAL MOTORS CORP.
  3. Remove the CMP sensor bolt and sensor (2).
About FixVault