FixVault
Home › Chevrolet › 2009 › Uplander Base, 3.9 1 › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 3.9L - Introduction (2 Of 2) › Repair Instructions › Crankshaft Position Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Identifying Crankshaft Position (CKP) Sensor
    GM1712672Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the CKP sensor O-ring with clean engine oil.
  2. Install the CKP sensor (1).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the CKP sensor stud (2) and tighten to 10 N.m (89 lb in)  .
  4. Connect the engine harness electrical connector to the CKP sensor.
  5. Install the exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side .
About FixVault