Electronic Brake Control Module Replacement and/or Reprogramming

If the electronic brake control module (EBCM) needs to be replaced and/or reprogrammed, the following procedures must be performed:

1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .
2. Perform the SPS function Electronic Brake Control Module - Programming and follow the on-screen instructions.
3. Place the front wheels and steering wheel in the straight ahead position.
4. Perform the SPS function Electronic Brake Control Module - Configuration & Setup and follow the on-screen instructions. Perform the following functions in this order:
   1. Programming
   2. Setup
5. Clear DTCs after completing the programming procedure.