FixVault
Home › Chevrolet › 2010 › Cobalt SS › Repair and Diagnosis › Brakes › Antilock Brake System With Traction Control System & Stability Control System › Repair Instructions › Brake Pressure Modulator Valve Bracket Replacement (With JL4) › Installation Procedure

Installation Procedure

    Fig 1: View Of BPMV Bracket Insulators
    GM1986382Courtesy of GENERAL MOTORS CORP.
  1. Install the BPMV bracket insulators (1).
    2. Fig 2: View Of Brake Pressure Modulator Valve Bracket Bolts
    GM1986381Courtesy of GENERAL MOTORS CORP.
  2. Install the BPMV bracket.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the 3 BPMV bracket bolts (1).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    4. Fig 3: View Of Brake Pressure Modulator Valve (BPMV) & Bracket
    GM1986380Courtesy of GENERAL MOTORS CORP.
  4. Install the BPMV (1) to the bracket by pressing the BPMV mounting pins into the bracket insulators until fully seated.
    5. Fig 4: View Of Brake Pressure Modulator Valve (BPMV)
    GM1986379Courtesy of GENERAL MOTORS CORP.
  5. Install the BPMV bolt (1).

    Tighten:  Tighten the bolt to 11 N.m (97 lb in).

  6. Install the brake pipes to the retainer on the wheelhouse panel.
  7. Install the cover to the ECM and TCM, if removed.
About FixVault