FixVault
Home › Chevrolet › 2010 › Cobalt SS › Repair and Diagnosis › Engine Mechanical › Engine Exhaust System › Repair Instructions › Front Wheel Drive Shaft Joint Boot Shield Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Wheel Drive Shaft Heat Shield
    GM878832Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel drive shaft heat shield into position on the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the wheel drive shaft heat shield bolt to the engine block and tighten the bolt to 30 N.m (22 lb ft).
  3. Install the wheel drive shaft heat shield bolt to the transaxle mount bracket and tighten the bolt to 10 N.m (89 lb in).
  4. Lower the vehicle.
About FixVault