Installation Procedure
Courtesy of GENERAL MOTORS CORP.
- Install a spring clip to the right and left side of the lift window panel aligning the lower edge of the clip with the upper edge of the auxiliary seal (1).
- Apply a thin continuous bead of weatherstrip sealant inside the forward lip of the lid.
- Apply a thin bead of sealant, on the lower side of the lip, from the corners up approximately 400 mm (16 in).
Courtesy of GENERAL MOTORS CORP.
- Position the weatherstrip to the panel.
- The curved surface of the weatherstrip must point up.
- Work from each end toward the centerline.
Courtesy of GENERAL MOTORS CORP.
- Align the small notch (3) near the end of the weatherstrip over the edge of the lift window panel.
- Insert the flange of the weatherstrip into the spring clip (2).
- Install the remainder of the weatherstrip (1).
- Install the lift window panel. Refer to Rear Compartment Lift Window Panel Replacement
.