Removal Procedure

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

Fig 1: View Of Brake Rotor (4WD, 1500 Series)
Courtesy of GENERAL MOTORS CORP.

WARNING: Refer to Brake Dust Warning .
Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
Remove the brake rotor (2) shown on the 1500 Series. Refer to Front Brake Rotor Replacement (JH5) or Front Brake Rotor Replacement (JH6, JH9) .

Fig 2: View Of Wheel Speed Sensor Cable & Connectors
Courtesy of GENERAL MOTORS CORP.
Remove the wheel speed sensor (WSS) cable mounting clip from the knuckle.
Remove the WSS cable mounting clip from the upper control arm.
Remove the WSS cable mounting clip from the frame attachment point.
Remove the WSS cable electrical connector.

Fig 3: View Of Wheel Speed Sensor Mounting Bolt
Courtesy of GENERAL MOTORS CORP.
Remove the WSS mounting bolt.
CAUTION: Carefully remove the sensor by pulling it straight out of the bore. DO NOT use a screwdriver, or other device to pry the sensor out of the bore. Prying will cause the sensor body to break off in the bore.

Fig 4: Identifying Brake/Hub Components
Courtesy of GENERAL MOTORS CORP.
Remove the wheel speed sensor (5) from the hub/bearing assembly (4) shown on the 2500/3500 Series.