FixVault
Home › Chevrolet › 2010 › HHR SS, Automatic › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Power Steering Assist Motor Replacement (Without SS) › Installation Procedure

Installation Procedure

    Fig 1: View Of Power Steering Assist Motor Shaft
    GM2075626Courtesy of GENERAL MOTORS CORP.
    NOTE: Use only the grease provided with the new power steering assist motor. Do not over apply it.
  1. Apply the grease into the power steering assist motor shaft.
    2. Fig 2: View Of Power Steering Assist Motor & Bolts
    GM2075607Courtesy of GENERAL MOTORS CORP.
    NOTE: The power steering assist motor should engage evenly and with ease. If it will not engage the reduction unit wormgear then remove the motor and try again. Do not force the motor and reduction unit together.
  2. Install the power steering assist motor (2).
  3. Grasp the power steering assist motor and hold it to the reduction unit while turning the steering shaft three full turns. This will center the and align the power steering motor shaft and the reduction unit wormgear.
    4. CAUTION: Refer to Fastener Caution .
    NOTE: Do not apply any load to the power steering assist motor while torquing the bolts or the realignment process described prior will need to be redone.
  4. Instal the power steering assist motor bolts (1) and tighten to 18.5 N.m (14 lb ft).
  5. Connect the power steering assist motor electrical connector.
  6. Install a new tie strap to the power steering assist motor.
  7. Install the steering column. Refer to Steering Column Replacement .
About FixVault