FixVault
Home › Chevrolet › 2010 › Malibu LS, 3.5 K › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 3.5L - Repair Instructions › Repair Instructions › Knock Sensor Replacement - Bank 1 › Installation Procedure

Installation Procedure

    Fig 1: Identifying Knock Sensor
    GM1800585Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Position the knock sensor to the engine block and install the knock sensor bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    2. Fig 2: Identifying Knock Sensor & CKP Engine Wiring Harness Connector
    GM1777192Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (1) to the knock sensor.
  3. Lower the vehicle.
About FixVault