FixVault
Home › Chevrolet › 2010 › Malibu LS, 3.5 K › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 3.5L - Repair Instructions › Repair Instructions › Spark Plug Wire Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Spark Plug Wire Assembly
    GM1798989Courtesy of GENERAL MOTORS CORP.
  1. Install the spark plug wire assembly.
  2. Connect the right side spark plugs to the ignition coils.
  3. Connect the right side spark plug wires to the spark plugs.
  4. If replacing only one plug wire, open the retaining clip and install the appropriate spark plug wire.
    5. Fig 2: View Of Left Side Spark Plug Wires
    GM1774994Courtesy of GENERAL MOTORS CORP.
  5. Install the spark plug wire assembly.
  6. Connect the left side spark plug wires to the spark plugs.
  7. Connect the left side spark plug wires to the ignition coil.
  8. Install the spark plug wire clips to the MAP sensor bracket and the heater inlet and outlet pipe tab.
  9. If replacing only one plug wire, open the retaining clips and install the appropriate spark plug wire.
  10. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
About FixVault