Removal Procedure
- The steering column
- The intermediate shaft(s)
- The steering gear
- Turn the steering wheel to the straight forward position and lock it in place.
- Remove the left front tire/wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Disengage the intermediate steering shaft boot from the steering gear and the intermediate steering shaft upper seal.
- Remove the intermediate steering shaft bolt (1) and separate the intermediate steering shaft from the steering gear.
- Remove the intermediate steering shaft boot (1).
CAUTION:
With wheels of the vehicle facing straight ahead, secure the steering wheel utilizing steering column anti-rotation pin, steering column lock, or a strap to prevent rotation. Locking of the steering column will prevent damage and a possible malfunction of the SIR system. The steering wheel must be secured in position before disconnecting the following components:
After disconnecting these components, do not rotate the steering wheel or move the front tires and wheels. Failure to follow this procedure may cause the SIR coil assembly to become un-centered and cause possible damage to the SIR coil. If you think the SIR coil has became un-centered, refer to your specific SIR coil's centering procedure to re-center SIR Coil.
After disconnecting these components, do not rotate the steering wheel or move the front tires and wheels. Failure to follow this procedure may cause the SIR coil assembly to become un-centered and cause possible damage to the SIR coil. If you think the SIR coil has became un-centered, refer to your specific SIR coil's centering procedure to re-center SIR Coil.
NOTE:
Do not tear the intermediate steering shaft boot.