FixVault
Home › Chevrolet › 2011 › Camaro LS, Automatic › Repair and Diagnosis › Engine Mechanical › Fuel System › Engine Controls And Fuel - 3.6L - Repair Instructions › Repair Instructions › Accelerator Pedal Position Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Locating APP Sensor And Fasteners
    GM1407620Courtesy of GENERAL MOTORS CORP.
  1. Install the APP sensor to the front of dash.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the APP sensor mounting nuts and tighten to 9 N.m (80 lb in).
  3. Connect the APP sensor electrical connector.
  4. Operate the accelerator pedal and observe the APP angles using a scan tool. The accelerator pedal should operate freely, without binding between closed throttle and wide open throttle.
  5. Install the closeout/insulator panel.
About FixVault