FixVault
Home › Chevrolet › 2011 › Caprice › Repair and Diagnosis › Brakes › Traction Control › Antilock Brake System › Repair Instructions › Rear Wheel Speed Sensor Replacement › Removal Procedure

Removal Procedure

WARNING:

Refer to Brake Dust Warning .

    Fig 1: Identifying Wheel Speed Sensor Jumper Harness Electrical Connector
    GM1943660Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Disconnect the rear wheel speed sensor electrical connector (1).
    4. Fig 2: Wheel Speed Sensor & Bolt
    GM2196958Courtesy of GENERAL MOTORS CORP.
  4. Clean the wheel speed sensor area on the suspension knuckle of any accumulated dirt and debris.
  5. Remove the wheel speed sensor bolt (1).
  6. Remove the wheel speed sensor assembly from the suspension knuckle by pulling straight out.
About FixVault