Installation Procedure
- Install the wheel speed sensor jumper harness (3) to the vehicle.
- Attach the wheel speed sensor wiring harness mounting clips (1) to the rear suspension subframe (2).
- Connect the left rear and right rear wheel speed sensor electrical connectors (1).
- Attach the wheel speed sensor wiring harness mounting clip (2) to the left rear and right rear knuckles.
- Attach the electrical connector (1) to the right hand rail (2).
- Connect the wheel speed sensor jumper harness electrical connector (1).
- Install the rear wheels. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
- Use the scan tool in order to clear any DTCs.
- Perform the System Check-Vehicle. Refer to Diagnostic System Check - Vehicle .
WARNING:
To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.
WARNING:
Refer to Safety Glasses Warning .
WARNING:
Refer to Brake Dust Warning .
NOTE:
Make sure the routing of the wheel speed sensor jumper harness (3) is routed in its original location.