FixVault
Home › Chevrolet › 2011 › Corvette Base, 2D Convertible, Standard › Repair and Diagnosis › Steering › Steering Wheel And Steering Column › Repair Instructions › Steering Column Telescope Switch Replacement › Installation Procedure

Installation Procedure

    Fig 1: Lower Trim Cover Tabs & Steering Column Close Out Trim Cover
    GM446719Courtesy of GENERAL MOTORS CORP.
  1. Install the telescope motor assembly switch and wires through the opening in the lower trim cover.
  2. Snap the wiring to the retaining clips in the lower trim cover.
  3. Route the switch wires to the telescope motor assembly along the column. Strap the wires in place.
  4. Connect the telescope motor assembly switch connector to the instrument panel wiring harness.
  5. Install the lower trim cover tabs into the steering column close out trim cover.
  6. Verify that the tabs on the lower trim cover are fully engaged with the slots in the steering column close out trim cover.
    7. Fig 2: TORX(R) Head Screws & Lower Trim Cover
    GM328799Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  7. Install the 2 TORX® head screws (1) to the lower trim cover.
  8. Install the driver knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .
  9. Install the tilt lever. Refer to Steering Column Tilt Wheel Release Lever Replacement .
  10. Enable the SIR system. Refer to SIR Disabling and Enabling .
About FixVault