FixVault
Home › Chevrolet › 2011 › Corvette Base, 2D Convertible, Standard › Repair and Diagnosis › Steering › Steering Wheel And Steering Column › Repair Instructions › Steering Column Tilt Spring Replacement (Telescoping) › Installation Procedure

Installation Procedure

    Fig 1: Spring Guide & Tilt Spring
    GM293250Courtesy of GENERAL MOTORS CORP.
  1. Install the spring guide into the tilt spring.
    2. Fig 2: Identifying Tilt Spring And The Steering Column Support Assembly
    GM293251Courtesy of GENERAL MOTORS CORP.
  2. Perform the following steps to install the tilt spring (1):
    1. Install the tilt spring (1) to the post on the steering column support assembly (2).
    2. Secure the tilt spring (1) with locking pliers.
    3. Push the guide end of the tilt spring (1) onto the post on the steering column tilt head assembly.
    4. Push the tilt spring (1) into position.
  3. Install the upper and lower trim covers. Refer to Steering Column Trim Cover Replacement (Telescoping)  or Steering Column Trim Cover Replacement (Manual) .
  4. Enable the SIR system. Refer to SIR Disabling and Enabling .
About FixVault