FixVault
Home › Chevrolet › 2011 › Cruze LS, Automatic › Repair and Diagnosis › Brakes › Traction Control › Antilock Brake System › Diagnostic Information and Procedures › Traction Control/Stability Control Indicator Malfunction › Circuit/System Testing

Circuit/System Testing

NOTE: Circuit/System Verification must be performed before Circuit/System Testing.
  1. Ignition OFF, disconnect the harness connector at the S75 Traction Control Switch.
  2. Test for less than 5 Ω between the ground circuit terminal 4 and ground.
    • If greater than the specified value, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify the scan tool BCM, Traction Control Switch parameter is Inactive.
    • If not the specified value, test the signal circuit for a short to ground. If the circuit tests normal, replace the K9 Body Control Module.
  4. Install a 3 A fused jumper wire between the signal circuit terminal 2 and ground.
  5. Verify the scan tool BCM, Traction Control Switch parameter is Active.
    • If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K9 Body Control Module.
  6. If all circuits test normal, test or replace the S75 Traction Control Switch.
About FixVault