FixVault
Home › Chevrolet › 2011 › Cruze LT › Repair and Diagnosis › Brakes › Traction Control › Antilock Brake System › Repair Instructions › Brake Pressure Modulator Valve Bracket Replacement › Removal Procedure

Removal Procedure

WARNING: Refer to Brake Fluid Irritant Warning .
CAUTION: Refer to Brake Fluid Effects on Paint and Electrical Components Caution .
  1. Turn the ignition to the OFF position.
    2. Fig 1: View Of Radiator Surge Tank And Radiator Surge Tank Clip
    GM2027873Courtesy of GENERAL MOTORS CORP.
    NOTE: Do NOT disconnect engine coolant hoses.
  2. Remove the radiator surge tank clip (2).
  3. Remove the radiator surge tank (1).

    Position the radiator surge tank (1) aside.

    4. CAUTION: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.
  4. Disconnect the electrical connector from the EBCM/EBTCM.
    5. Fig 2: BPMV Brake Lines
    GM2027877Courtesy of GENERAL MOTORS CORP.
    NOTE: Cap the brake pipe fittings to prevent brake fluid loss and contamination.
  5. Remove the 6 brake pipes (1, 2) from the BPMV.
    6. Fig 3: BPMV and BMPV Bracket Bolts
    GM2027887Courtesy of GENERAL MOTORS CORP.
  6. Remove the 2 BPMV bracket bolts (2).
  7. Remove the BPMV bracket assembly (1).
    8. Fig 4: BPMV and BPMV Bracket Bolts
    GM2027916Courtesy of GENERAL MOTORS CORP.
  8. Remove the 3 BPMV bracket bolts.
  9. Remove the BPMV (2).
  10. Remove the BPMV insulator (1) from the BPMV bracket (3).
About FixVault