FixVault
Home › Chevrolet › 2011 › Cruze LTZ › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 1.4L (LUJ) - Repair Instructions › Repair Instructions › Fuel Feed Pipe Replacement › Removal Procedure

Removal Procedure

WARNING: Refer to Gasoline/Gasoline Vapors Warning .
  1. Open the hood.
  2. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Relieve the fuel pressure. Refer to Fuel Pressure Relief .
    4. Fig 1: Fuel Feed Pipe
    GM2373056Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the fuel feed pipe connector (3) from fuel injector rail. Refer to Plastic Collar Quick Connect Fitting Service .
  5. Unclip the fuel feed pipe (1) from the retainer clip (4).
  6. Close the fuel feed pipe connector with a suitable cap.
  7. Unclip the fuel feed pipe from the bulk head retainer clip (2).
  8. Remove the drivetrain and front suspension frame. Refer to Drivetrain and Front Suspension Frame Replacement .
    9. Fig 2: Fuel Feed Pipe And Clips
    GM2191622Courtesy of GENERAL MOTORS CORP.
  9. Open the 4 fuel pipe clips (2).
  10. Remove the fuel feed pipe (1) from lower bulkhead and underbody.
    11. Fig 3: Fuel Tank Feed Pipe Connector
    GM2373058Courtesy of GENERAL MOTORS CORP.
  11. Disconnect the fuel tank feed pipe connector (1) from the fuel feed pipe. Refer to Plastic Collar Quick Connect Fitting Service .
  12. Close the fuel feed pipe and fuel tank feed pipe with suitable caps.
  13. Disconnect the fuel pressure sensor wiring harness plug (2).
  14. Open the rear fuel pipe clip and remove the fuel feed pipe.
About FixVault