Component Testing

Driver Seat Memory Switch

1. Disconnect the harness connector at the S47D driver seat memory switch.
2. Test for infinite resistance between the low reference terminal 1 and the signal terminals listed below with the switch in the open position.
   • Terminal 5
   • Terminal 6
   • If not the specified value, replace the S47D driver seat memory switch.
3. Test the resistance between terminal 1 and terminal 6 while pressing the memory 1 and memory 2 buttons. Compare the resistance readings to the values in the Memory Switch Values table below.
   • If the resistance is not within the specified range, replace the S47D driver seat memory switch.
4. Test for less than 1 Ω between terminal 1 and terminal 5 while pressing the memory set switch.
   • If greater than the specified range, replace the S47D driver seat memory switch.