FixVault
Home › Chevrolet › 2011 › HHR LS, Automatic › Repair and Diagnosis › External Pages › Different car › Section 108 (Front Suspension System) › Repair Instructions › Strut Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Front Suspension Strut
    GM2003673Courtesy of GENERAL MOTORS CORP.
  1. Position the front suspension strut (2) in the vehicle (1).
    2. Fig 2: View Of Front Suspension Strut Stud & Mounting Nut
    GM2003661Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the front suspension front mounting nuts (1) on the front suspension strut studs (2).

    Tighten:  Tighten the front suspension front mounting nuts (1) to 20 N.m (15 lb ft).

  3. Using the adjustable jack stand, lift the lower control arm to allow the installation of the front suspension strut.
    4. Fig 3: Identifying Front Suspension Strut & Bolts
    GM2005989Courtesy of GENERAL MOTORS CORP.
  4. Install the front suspension strut bolts (2) in the front suspension strut (1).
    5. Fig 4: View Of Front Suspension Strut Nut & Bolts
    GM2005976Courtesy of GENERAL MOTORS CORP.
  5. Reconnect the wheel speed sensor electrical connectors (3) and (4).
  6. Position the wheel speed sensor bracket (1) on the front suspension strut bolts (5).
  7. Install the front suspension strut nuts (2) on the front suspension strut bolts (5).

    Tighten:  Tighten the front suspension strut nuts to 120 N.m (89 lb ft).

  8. Install the stabilizer shaft link the front suspension strut. Refer to Stabilizer Shaft Link Replacement .
  9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  10. Align the front end. Refer to Wheel Alignment Specifications .
About FixVault