FixVault
Home › Chevrolet › 2011 › HHR LS, Standard › Repair and Diagnosis › External Pages › Different car › Section 106 (Battery, Charging System And Starting System) › Repair Instructions › Battery Current Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Battery Current Sensor
    GM1631638Courtesy of GENERAL MOTORS CORP.
  1. Install the battery current sensor by passing the ground end of the negative battery cable through the sensor.
    2. Fig 2: Identifying Negative Battery Cable
    GM1631636Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure the battery current sensor is installed in the previous location on the negative battery cable.
  2. Fasten the battery current sensor with electrical tape to the negative battery cable.
  3. Install the negative battery cable to the battery. Refer to Battery Negative Cable Replacement .
About FixVault