FixVault
Home › Chevrolet › 2011 › HHR LS, Standard › Repair and Diagnosis › External Pages › Different car › Section 110 (Wheel Alignment System) › Repair Instructions › Front Camber Adjustment

Front Camber Adjustment

WARNING: This page is about a different car, the 2009 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen both strut to knuckle nuts just enough to allow for movement.
    2. Fig 1: View Of Front Camber-Modifying Strut
    GM866401Courtesy of GENERAL MOTORS CORP.
  2. If the strut has not been modified previously, perform the following steps before continuing with the wheel alignment:
    1. Disconnect the strut from the knuckle. Refer to Strut Replacement .
    2. File the lower hole until the groove of the stamped ring around the hole.
    3. Connect the strut to the knuckle. Refer to Strut Replacement .
    3. Fig 2: Illustrating Camber Adjustment
    GM165165Courtesy of GENERAL MOTORS CORP.
  3. Adjust the camber to specification by moving the top of the wheel in or out. Refer to Wheel Alignment Specifications .
About FixVault