FixVault
Home › Chevrolet › 2011 › HHR LS, Standard › Repair and Diagnosis › External Pages › Different car › Section 129 (Engine Controls And Fuel - 2.0L - Introduction) › Repair Instructions › Accelerator Pedal Position Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying APP Sensor
    GM1633085Courtesy of GENERAL MOTORS CORP.
  1. Install the APP sensor.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the APP sensor nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

    3. Fig 2: Identifying APP Sensor Electrical Connector
    GM1633081Courtesy of GENERAL MOTORS CORP.
  3. Connect the APP sensor electrical connector (1).
  4. Install the insulator panel. Instrument Panel Insulator Replacement .
About FixVault