FixVault
Home › Chevrolet › 2011 › HHR LS, Standard › Repair and Diagnosis › External Pages › Different car › Section 39 (Sunroof System) › Repair Instructions › Sunroof Module Assembly Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Sunroof Motor/Actuator Electrical Connector
    GM861204Courtesy of GENERAL MOTORS CORP.
  1. Remove the sunshade panel. Refer to Sunroof Sunshade Replacement .
  2. Remove the sunroof window. Refer to Sunroof Window Replacement .
    3. IMPORTANT: It is only necessary to lower the headliner. Only do the steps in headliner replacement that will lower the headliner enough to gain access.
  3. Lower the headliner. Refer to Headlining Trim Panel Replacement .
  4. Disconnect the electrical connector on the sunroof actuator.
  5. Disconnect the electrical connector from the sunroof module.
    6. Fig 2: Sunroof Module Assembly
    GM1547329Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the front and rear drain hoses (1) from the drain spouts on the sunroof module.
    7. IMPORTANT: Remove the 2 center nuts last in order to help support the sunroof module to the roof ring.
  7. Remove the sunroof module nuts (2) from the roof.
  8. Remove the center nuts from the sunroof module.
  9. With the aid of an assistant, lower and remove the sunroof module assembly out through the liftgate opening.
  10. Transfer all components to the new module as needed.
About FixVault