FixVault
Home › Chevrolet › 2011 › Impala LT › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 3.5L - DTC P0010 Through DTC P0340 › DTC P0011 › Component Testing › Dynamic Test

Dynamic Test

  1. Ignition OFF, remove the Camshaft Position Actuator Magnet.
    2. NOTE:
    • The Camshaft Position Actuator Magnet pintle should be facing downward for this test.
    • Do not allow electrical current to flow through the Camshaft Position Actuator Magnet for greater than 1-2 s.
  2. Install a 20 A fused jumper wire between the control circuit terminal 1 and B+. Momentarily install a jumper wire between the low reference terminal 2 and ground. The pintle should extend.
    • If the function does not perform as specified, replace the Camshaft Position Actuator Magnet.
About FixVault