Front Brake Caliper Replacement

WARNING: This page is about a different car, the 2010 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Replacing Front Brake Caliper

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: Refer to Brake Dust Warning . WARNING: Refer to Brake Fluid Irritant Warning . Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
1	Brake Hose Fitting Bolt CAUTION: Refer to Fastener Caution . Tighten: 54 N.m (40 lb ft)
2	Brake Hose Fitting Gasket (Qty: 2) Tip: DO NOT reuse the brake hose fitting gaskets. Install NEW gaskets.
3	Brake Hose Tip: Cap the brake hose fitting to prevent brake fluid loss and contamination.
4	Guide Pin Bolt (Qty: 2) Tighten: 36 N.m (26 lb ft)
5	Brake Caliper Procedure Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) . With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance. Slowly release the brake pedal. Wait 15 seconds, then repeat steps 2-3 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads. Fill the master cylinder reservoir to the proper level. Refer to Master Cylinder Reservoir Filling . Burnish the pads and rotors. Refer to Brake Pad and Rotor Burnishing .