FixVault
Home › Chevrolet › 2011 › Traverse LS, AWD › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Power Steering Fluid Reservoir Replacement › Installation Procedure

Installation Procedure

    CAUTION:

    Refer to Fastener Caution .

    Fig 1: Locating Power Steering Fluid Reservoir & Bolts
    GM1856562Courtesy of GENERAL MOTORS CORP.
  1. Install the remote power steering fluid reservoir (2).
  2. Install the remote power steering fluid reservoir bolts (1) and tighten to 9 N.m (80 lb in).
    3. Fig 2: View Of Power Steering Fluid Reservoir Outlet Hose & Clamp
    GM1856009Courtesy of GENERAL MOTORS CORP.
  3. Connect the power steering fluid reservoir outlet hose and clamp (1).
    4. Fig 3: Identifying Power Steering Reservoir Inlet Hose & Clamp
    GM1856010Courtesy of GENERAL MOTORS CORP.
  4. Connect the power steering reservoir inlet hose and clamp (1).
  5. Clean all excess fluid from the vehicle and remove the drain pans.
  6. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
  7. Install the fuel injector sight shield. Refer to FUEL INJECTOR SIGHT SHIELD REPLACEMENT .
About FixVault