FixVault
Home › Chevrolet › 2011 › Traverse LS, FWD › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 3.6L - Repair Instructions › Repair Instructions › Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust › Installation Procedure

Installation Procedure

    Fig 1: View Of CMP Sensor Bolt & Sensor
    GM1860459Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  1. Install the CMP sensor (4) and bolt.

    Tighten 

    Tighten the bolt to 10 N.m (89 lb in).

    2. Fig 2: Identifying Intake & Exhaust Camshaft Position (CMP) Sensors
    GM1860429Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (3) to the bank 2 exhaust CMP sensor (4).
  3. Install the engine mount strut bracket. Refer to ENGINE MOUNT STRUT BRACKET REPLACEMENT - RIGHT SIDE .
About FixVault