Relay Test
- Ignition OFF, disconnect the appropriate relay.
- Test for 60-180 Ω between terminals 1 and 2.
- If the not within the specified range, replace the relay.
- Test for infinite resistance between the following terminals:
- 3 and 2
- 3 and 5
- 3 and 1
- 1 and 5
- If not the specified value, replace the relay.
- Install a 5 A fused jumper wire between relay terminal 2 and 12 V. Install a jumper wire between relay terminal 1 and ground. Test for less than 2 ohms between terminals 3 and 5.
- If greater than the specified range, replace the relay.