Inspection Procedure
- Inspect the outer tie rod seal. If the outer tie rod seal is torn, replace the outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Install the GE-8001: dial indicator between the outer tie rod and the steering knuckle as shown in the illustration. Note that the tire and wheel assembly is shown removed only for clarification of the GE-8001: dial indicator position.
- Grasping the tire at the 3 o'clock (2) and 9 o'clock (1) positions, gently push in on one side of the tire in order to remove any lash.
- Zero the GE-8001: dial indicator.
- On the same side of the tire previously pushed inwards, gently pull outwards and measure the lash.
- Record the measurement shown on the GE-8001: dial indicator.
- If the measured value exceeds 0.5 mm (0.02 in), replace the outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
- Repeat the procedure for the other side.
NOTE:
This inspection procedure does not supersede local government required inspections that have more stringent requirements.
WARNING:
Do not use a service jack to lift this vehicle. Lifting the vehicle with a jack could cause the vehicle to slip off the jack and roll; this could cause injury or death.