FixVault
Home › Chevrolet › 2012 › Camaro LS, Automatic Trans › Repair and Diagnosis › Body & Frame › Fixed And MOVEABLE Windows › Repair Instructions › Quarter Window Replacement - Brazil › Installation Procedure

Installation Procedure

  1. If reusing or replacing the window, use the appropriate tool, remove the auto-adhesive bead on the window surface and pinch-weld flange to approximately 2 mm (0.078 in).
    2. Fig 1: Applying Glass Prep
    GM379890Courtesy of GENERAL MOTORS COMPANY
  2. Clean the bonding area on the window.
    3. Fig 2: Applying Glass Prep
    GM161424Courtesy of GENERAL MOTORS COMPANY
  3. Apply bonded-glass primer and let dry per auto-adhesive instructions by the manufacturer's.
    4. Fig 3: Applying Glass Primer
    GM245290Courtesy of GENERAL MOTORS COMPANY
  4. Apply the auto-adhesive primer-application (2) around the perimeter of the rear window (1) and let dry per auto-adhesive instructions by the manufacturer's.
    5. Fig 4: View Of Modified Applicator Nozzle
    GM161427Courtesy of GENERAL MOTORS COMPANY
  5. Cut the applicator nozzle to provided a V cut to apply the auto-auto-adhesive.
    6. NOTE:

    If the locating pins were cut off it will be necessary to tape the window in place until the auto-adhesive cures per auto-adhesive instructions by the manufacturer's.

  6. Gently press the quarter window into the auto-adhesive bead until it fully seats evenly in the open.
  7. Use masking tape to hold the window in the position until the auto-adhesive completely cures.
  8. Make sure to observe the auto-adhesive curing time before releasing the vehicle per auto-adhesive instructions by the manufacturer's.
    9. NOTE:

    Following the auto-adhesive installation instructions, using nafta to remove any excess of auto-adhesive within 30 minutes, otherwise it will not be possible to remove the auto-adhesive excess unless using mechanical means.

  9. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
    10. NOTE:

    Do not direct a hard stream of high pressure water to the freshly applied auto-adhesive.

  10. Use a soft spray of warm water in order to immediately water test the window.
  11. Inspect the window for leaks.
  12. If any leaks are found, use a plastic paddle in order to apply extra auto-adhesive at the leak point.
  13. Retest the window for leaks.
  14. Maintain the following conditions in order to properly cure the auto-adhesive:
    • Partially lower a door window in order to prevent pressure buildups when closing doors before the auto-adhesive cures.
    • Do not drive the vehicle until the auto-adhesive is cured. Refer to the above curing times.
    • Do not use compressed air in order to dry the auto-adhesive.
    15. Fig 5: Cleaning Excess Urethane Adhesive From Body
    GM706194Courtesy of GENERAL MOTORS COMPANY
  15. Clean any excess auto-adhesive from the body.
About FixVault